Installation Guide
Tools Needed:
- Adjustable wrench
- Level
- Screwdrivers (flat and Phillips)
- Pipe wrench (gas models)
- Tape measure
- 4-inch duct clamps
Step-by-Step Installation
- Choose Installation Location: Select a location with proper ventilation, near electrical/gas connections on a solid, level floor.
- Remove Shipping Materials: Remove all shipping bolts and packaging materials from the dryer.
- Connect Exhaust Vent: Install 4-inch diameter metal exhaust duct, avoid sharp bends and keep duct as short as possible.
- Gas Connection (Gas Models): Connect gas line using approved flexible connector, check for leaks with soap solution.
- Electrical Connection: Connect to properly grounded 120V, 60Hz outlet (electric) or 240V outlet (electric heating models).
- Level the Dryer: Adjust the leveling legs to ensure the dryer is level from front to back and side to side.
- Test Run: Run the dryer through a complete cycle to check for proper operation and ventilation.
Specifications
| Model Series | WED5000DW / WGD5000DW |
| Type | Electric & Gas Dryers |
| Color | White / Stainless Steel |
| Capacity | 7.0 cu. ft. |
| Noise Level | 65 dB |
| Control Type | Electronic Controls with LED Display |
| Energy Rating | ENERGY STAR® Certified |
| Power Requirements (Electric) | 240V, 30A |
| Gas Requirements | Natural Gas / LP Gas |
| Dimensions (HxWxD) | 43 x 29 x 29 inches |
| Weight | 125 lbs (Electric) / 130 lbs (Gas) |
| Exhaust Requirements | 4-inch diameter metal duct |
Warranty Information
- Full Warranty: 1 year parts and labor
- Motor Warranty: 10 years on dryer motor
- Drum Warranty: Lifetime limited warranty
- Additional Coverage: Optional extended warranty available
For warranty service, contact Whirlpool Customer Service at 1-800-253-1301 or visit Whirlpool.com
Key Features
Advanced Moisture Sensing
Automatically senses when clothes are dry and shuts off, preventing over-drying and saving energy while protecting your fabrics.
Wrinkle Shield™ Option
Keeps clothes moving periodically after the cycle ends to help prevent wrinkles from setting in when you can't unload immediately.
AccuDry™ Temperature Control
Monitors and maintains consistent temperatures throughout the cycle for even drying and fabric protection.
Steam Refresh Cycle
Uses steam to remove wrinkles and odors from clothes that have been sitting in the dryer or closet, refreshing them without washing.
Quick Dry Cycle
Dries small loads quickly and efficiently, perfect for when you need specific items in a hurry.
Quiet Operation
Sound insulation and balanced drum system provide quiet operation even during heavy use cycles.
Drying Cycles Explained
Auto Dry
Automatically adjusts drying time based on moisture level for optimal results
Timed Dry
Manual control for specific drying times from 10 to 180 minutes
Wrinkle Control
Periodic tumbling after cycle ends to prevent wrinkles
Air Fluff
No heat cycle for freshening pillows, stuffed animals, and delicate items
Heavy Duty
Extended high-heat cycle for bulky items like towels and jeans
Delicates
Low heat setting for delicate fabrics and special care items
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Dryer won't start | Power issue, door not closed, start button not held | Check power supply, ensure door is latched, hold start button for 3 seconds |
| No heat | Thermal fuse blown, heating element failed, gas valve issue | Check thermal fuse, test heating element, verify gas supply (gas models) |
| Takes too long to dry | Clogged lint filter, restricted vent, overloaded | Clean lint filter, check vent system, reduce load size |
| Unusual noises | Worn rollers, idler pulley, blower wheel obstruction | Inspect and replace rollers/idler, check blower wheel |
| Clothes too hot | Faulty thermostat, cooling timer issue | Test thermostats, check cooling cycle operation |
| Vibration during operation | Unbalanced load, uneven floor, worn shock absorbers | Redistribute load, level the dryer, check shock absorbers |
Error Codes
- F1: Main control failure - Reset dryer, check control board
- F2: Thermistor open - Check temperature sensor
- F3: Thermistor short - Replace temperature sensor
- F5: Thermal cutoff open - Check thermal fuse and thermostats
- F7: Motor triac - Check drive motor and control board
- F8: Moisture sensor - Clean moisture sensor bars
Manual Downloads
Current Model Manuals
WED5000DW
7.0 cu. ft. Electric Dryer
WGD5000DW
7.0 cu. ft. Gas Dryer
WED5620HW
7.0 cu. ft. Smart Dryer
WGD5620HW
7.0 cu. ft. Smart Gas Dryer
Popular Previous Models
WED4815EW
7.0 cu. ft. Electric Dryer
WGD4815EW
7.0 cu. ft. Gas Dryer
WED9200YW
9.0 cu. ft. Electric Dryer
WGD9200YW
9.0 cu. ft. Gas Dryer